PLEASE USE YOUR FULL NAME OR THE POST WILL BE DELETED. INAPPROPRIATE LANGUAGE WILL GET YOU BANNED. PLEASE BE CONSCIOUS THAT THESE ARE PUBLIC POSTS. PLEASE BE CONSIDERATE OF CHILDREN THAT MAY BE SIGNED ON.
Just be sure to write down your track and train codes so that if one does loose signal you can just remove it and add it back by putting in the train code without having to be near the collar. The collar keeps the same codes and Id unless you change it.
Did have a problem with one of my Alpha collars last Saturday when hunting with a club. Normally turn on all my collars after Hunt master draws up a hunt and so do other dog drivers. If a collar does not receive satellite uplink from info screen or interferes, I will delete that collar and re add, again going back to Info screen to make sure collar has satellite uplink before turning that dog loose. This one collar did receive satellite uplink until delete and re entered. No interfere was ever show at all day with this collar. That afternoon, a red triangle shown up on my alpha screen ( two others also ) point to the collar location. This location was correct for other hunters dog( same club) who had the same tracking code #. The other point was the location off my dog about 2 miles away. Has any experienced this before ? It was suggested that we delete all collars ( no preload # ) and re enter at the start of the hunt.
I had the dog on the screen for a couple of hours and then the collar dropped the GPS signal and just never picked it back up. Once I caught the dog and rebooted the collar it started working again just fine. I've gone through and reset and updated everything. I still have an issue where I can update the collar to the latest firmware and the garmin webupdater will always say there is an update available so I don't know if my collars are updated or not. They go through the whole process and beep and turn off when the updated says the install process is complete. Be nice if it told me there were no more updates like it does for the alpha unit though.
Call Bill Grey at Outdoor Dog Supply... They will be more than glad to try to help you get to the bottom of this...There # is 757 498-0101... These are the best people Ive ever dealt with on Garmin stuff... Hope this helps some...
Glitches like this is why I still run beeper collars... GPS collars are computers and they will glitch... just a thought...